Accessories

Configure your Lexmark

Supports up to a total of 3000 sheets. Only Letter paper size is supported for card stock and various plain, recycled or bond papers in this tray. Tray-present, paper-present and paper-low sensing are supported. Installs on the right side of the printer or MFP. The 2500-Sheet Tandem Tray or 2x 500-Sheet Tray is required to use the 3000-Sheet tray, or to raise the printer or MFP to the correct height for use with the Staple Punch Finisher or the Booklet Finisher.

Configure your Lexmark

Attaches to the right of the scanner

Configure your Lexmark

The Banner Media Tray is an extension of the Multi Purpose Feeder and allows the automatic feeding of up to 10 sheets of banner paper.This tray supports banner paper in sizes from 8.27 to 11.69 inches wide (21 to 29.7 cm) to 18 to 47.24 inches long (45.7 to 120 cm). Banner paper is not supported using duplex mode. Banner paper is not supported with a finisher.

Configure your Lexmark

Adds ~ 25.4 cm to height and raises the device for use with a finisher. Extra paper or supplies can be stored inside the cabinet.

The Parallel 1284-B Interface Card installs into the printer's internal port. It supports a parallel 1284-B compliant interface using a 36-pin D-shell female, bi-directional connector. It is recommended that a Lexmark 10' Parallel cable (P/N 1021231) or a bidirectional IEEE 1284 complaint cable be used to avoid compatibility problems.